The Lincoln Ranger 250 GXT comes standard with all the extra features for maintenance and construction. The new Lincoln Electric Ranger 250 is capable of producing up to an incredible 250 amps for AC or DC stick and wire welding. You can also get a handy remote which gives you more precise amperage control for AC TIG welding on aluminum.
The Ranger 250 has auxillary output of 11,000 watts peak, for lights, grinders or equipment.
Rated 250 amps. 100% duty cycle.
AC/DC welding output with stick electrodes or MIG, flux-cored, and TIG welding.
11,000 Watts Peak Single-Phase AC Generator in case you need auxillary power.
For high capacity needs such as a back-up generator.
For lights, a grinder or other any other electric power tools.
Engine doors provide protection and easy service access.
Rugged Reliability in a wide variety of environmental conditions.
Weight:602 lbs.
Dimensions 36.2 x 21.5 x 42.3 inches
 |
Welder Rheostat For Ranger 250 |
| $48.99 USD (0 Bids) |
Ships to: US for $20.00 |
Ends: 3 day 5 hours |
| Seller: taraprft09 (100.0% Positive) |
Location: Lebanon, VA, US |
|
If you don’t see what you are looking for, Click Here to see all the results on eBay.
Similiar items:
This is a pretty solid welder. I really don’t have any complaints about it.
- Jim
I agree. The Lincoln Ranger 250 is a good welder. This is my main welder for anything outside of the shop. Only small complaint was the controls took a little while to figure out. Other than that the Ranger 250 GXT is one of the best welders I have used. The arc is incredibly stable, and also very easy to strike.
thats for sure, guy
will you sell it for $ 3,000 dollares?
Overall a good portable welder, bought mine new. BUT, mine had a gas tank leak when it was filled up. A totally unacceptable situation. Leaked all over the back of the truck and onto ground afterward. Will see how the warranty is handled tomorrow when the dealer opens.
1 Issue is that when welding at lower amps - say 50 amps - full ac current from the auxiliary outlet is not available. The fine control for selecting welding amps also determines output current on the auxiliary output. So any welding amp selection which is below 7 on the fine control of the machine will not give you enough auxiliary current for electrical equipment.